[Cryptech-Commits] [sw/stm32] 01/02: Add n25q128_erase_bulk
git at cryptech.is
git at cryptech.is
Wed Feb 15 16:39:46 UTC 2017
This is an automated email from the git hooks/post-receive script.
paul at psgd.org pushed a commit to branch ksng
in repository sw/stm32.
commit f6674bdbc765466ba709230a1db669401b8263cc
Author: Paul Selkirk <paul at psgd.org>
AuthorDate: Wed Feb 15 11:22:03 2017 -0500
Add n25q128_erase_bulk
---
spiflash_n25q128.c | 57 +++++++++++++++++++++++++++++++++++++++++++++++++-----
spiflash_n25q128.h | 2 ++
2 files changed, 54 insertions(+), 5 deletions(-)
diff --git a/spiflash_n25q128.c b/spiflash_n25q128.c
index c23f244..68f96f1 100644
--- a/spiflash_n25q128.c
+++ b/spiflash_n25q128.c
@@ -6,7 +6,7 @@
* The Alpha board has two of these SPI flash memorys, the FPGA config memory
* and the keystore memory.
*
- * Copyright (c) 2016, NORDUnet A/S All rights reserved.
+ * Copyright (c) 2016-2017, NORDUnet A/S All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions are
@@ -35,9 +35,7 @@
* SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
-#include "stm32f4xx_hal.h"
-#include "stm-fpgacfg.h"
-#include "stm-init.h"
+#include "spiflash_n25q128.h"
#define _n25q128_select(ctx) HAL_GPIO_WritePin(ctx->cs_n_port, ctx->cs_n_pin, GPIO_PIN_RESET);
#define _n25q128_deselect(ctx) HAL_GPIO_WritePin(ctx->cs_n_port, ctx->cs_n_pin, GPIO_PIN_SET);
@@ -222,7 +220,7 @@ inline int _wait_while_wip(struct spiflash_ctx *ctx, uint32_t timeout)
int i;
while (timeout--) {
i = n25q128_get_wip_flag(ctx);
- if (i < 0) return 0;
+ if (i < 0) return 0; // impossible
if (! i) break;
HAL_Delay(10);
}
@@ -294,6 +292,54 @@ int n25q128_erase_subsector(struct spiflash_ctx *ctx, uint32_t subsector_offset)
}
+int n25q128_erase_bulk(struct spiflash_ctx *ctx)
+{
+ // tx buffer
+ uint8_t spi_tx[1];
+
+ // result
+ HAL_StatusTypeDef ok;
+
+ // enable writing
+ spi_tx[0] = N25Q128_COMMAND_WRITE_ENABLE;
+
+ // select, send command, deselect
+ _n25q128_select(ctx);
+ ok = HAL_SPI_Transmit(ctx->hspi, spi_tx, 1, N25Q128_SPI_TIMEOUT);
+ HAL_Delay(1);
+ _n25q128_deselect(ctx);
+
+ // check
+ if (ok != HAL_OK) return 0;
+
+ // make sure, that write enable did the job
+ int wel = _n25q128_get_wel_flag(ctx);
+ if (wel != 1) return 0;
+
+ // send command
+ spi_tx[0] = N25Q128_COMMAND_ERASE_BULK;
+
+ // activate, send command, deselect
+ _n25q128_select(ctx);
+ ok = HAL_SPI_Transmit(ctx->hspi, spi_tx, 1, N25Q128_SPI_TIMEOUT);
+ HAL_Delay(1);
+ _n25q128_deselect(ctx);
+
+ // check
+ if (ok != HAL_OK) return 0;
+
+ // wait for erase to finish
+
+ if (! _wait_while_wip(ctx, 60000)) return 0;
+
+ // done
+ return 1;
+}
+
+
+/*
+ * Read the Write Enable Latch bit in the status register.
+ */
int _n25q128_get_wel_flag(struct spiflash_ctx *ctx)
{
// tx, rx buffers
@@ -319,6 +365,7 @@ int _n25q128_get_wel_flag(struct spiflash_ctx *ctx)
return ((spi_rx[1] >> 1) & 1);
}
+
/* This function performs erasure if needed, and then writing of a number of pages to the flash memory */
int n25q128_write_data(struct spiflash_ctx *ctx, uint32_t offset, const uint8_t *buf, const uint32_t len, const int auto_erase)
{
diff --git a/spiflash_n25q128.h b/spiflash_n25q128.h
index c696911..41b6101 100644
--- a/spiflash_n25q128.h
+++ b/spiflash_n25q128.h
@@ -46,6 +46,7 @@
#define N25Q128_COMMAND_WRITE_ENABLE 0x06
#define N25Q128_COMMAND_ERASE_SECTOR 0xD8
#define N25Q128_COMMAND_ERASE_SUBSECTOR 0x20
+#define N25Q128_COMMAND_ERASE_BULK 0xC7
#define N25Q128_COMMAND_PAGE_PROGRAM 0x02
#define N25Q128_PAGE_SIZE 0x100 // 256
@@ -75,6 +76,7 @@ extern int n25q128_read_page(struct spiflash_ctx *ctx, uint32_t page_offset, uin
extern int n25q128_write_page(struct spiflash_ctx *ctx, uint32_t page_offset, const uint8_t *page_buffer);
extern int n25q128_erase_sector(struct spiflash_ctx *ctx, uint32_t sector_offset);
extern int n25q128_erase_subsector(struct spiflash_ctx *ctx, uint32_t subsector_offset);
+extern int n25q128_erase_bulk(struct spiflash_ctx *ctx);
extern int n25q128_write_data(struct spiflash_ctx *ctx, uint32_t offset, const uint8_t *buf, const uint32_t len, const int auto_erase);
extern int n25q128_read_data(struct spiflash_ctx *ctx, uint32_t offset, uint8_t *buf, const uint32_t len);
More information about the Commits
mailing list